Latest Posts

How to make a Kid’s Desk

How to make a Kid’s Desk

Introduction This kid's desk uses a tongue, slot and wedge system to hold most of it together.The desk frame is made up of interlocking 3/4"(18mm) thick plywood panels: spacer panels and side ...

How to make a Track Dolly

Track Dolly

Introduction and materials Because we tend to be focusing more and more on videoing Buildeazy projects, we try to improve production as we go and occasionally we get - or make - a new tool to ...

Build a Garden Chair

garden chair build start

Garden chair project by Les Kenny This is a very comfortable garden chair and it doesn't look too bad either. It would pretty much look good in any garden. Made out of mostly 140mm x 35mm ...

Side Coffee Table Project

Side Coffee Table

Introduction All measurements throughout this project are given in both Metric (mm) and Standard/Imperial inches.The measurements are given first in millimeters (mm), followed by inches in ...

How to build a peaked top arbor

arbor 45degree roof

Introduction and lumber requirements This arbor is a solid construction with 100x100 (4x4) posts concreted into the ground, 100x50 (2x4) rafters, 50x50 (2x2) roof frame members and 50x50 (2x2) ...

How to build a dollhouse

How to build a dollhouse

Preface How it started "Granddad, could you please make me a dollhouse for my birthday?"That's where it all started.I had made dollhouses before for my kids, but that was some thirty years ...

How to make an elf cave

hobit 300x280

Preface I first co-authored this project with my daughter Roseanne in 2004-2005. It was one of five projects we were commissioned to do for a book called 'DIY for kids - book two'. That book ...

How to make a shed floor

How to make a shed floor

Introduction - Floor plan This article explains how a temporary floor was made for a galvanized steel shed.We emphasize 'temporary' because the floor was not anchored to the ground in any ...

Gated arbor

gate_arbor_gate_double

Build a gated arbor by Les Kenny Introduction and lumber requirements This narrow (depthwise) gated arbor is basically two gate posts with an overhead top consisting of two short decorative ...

A trellis top gate

gate trellis

This project "how to build a gate" to match a trellis top fence was sent to us by Esteban Ramirez, Pinole CA/USA. Materials: Three 2"X4"X8' for the gate sides.One 2X2.Four 90 degrees angle ...

How to build an Entry Arbor

arbor 300x220

Introduction: An arbor or a pergola? This structure might be called either an arbor or a small pergola, but we will call it an arbor. What's the difference? Definition of an arbor A ...

How to make a boot bench

Boot Bench

This complete plan-set can be purchased in downloadable PDF format with more pictures free of advertising and print friendly. Introduction This handy boot bench can be made in just a ...

How to make a step stool

photo-step-stool-green

Introduction and plans This step stool is a very practical, multi-purpose unit which would find a place in just about any house. It serves as a set of steps, a seat and a stand, all in one.The ...

How to build a mailbox

MailBox

This type of wooden mailbox is along the lines of 'letterboxes' more likely to be found in the City Suburbs of Australasia.US mailboxes are designed differently and for the most have postal ...

BuildEazy
Logo
Enable registration in settings - general
Shopping cart